Epoxy Rust Converter: JENOLITE Rust Converter Epoxy Aerosol quickly neutralizes rust and prepares surfaces for painting. It provides long-term protection against moisture and corrosion. Coverage: 2m² per 400ml.
Made in Britain.
PREPARE FOR PAINT
Stabilises the surface and forms a protective coating on drying. Forming a barrier to water vapour, oxygen and carbon dioxide; whilst resisting salt spray and bacterial growth.
HOW TO USE
Remove all traces of oil or grease. Remove old paint and loose rust with steel wool or wire brush.
1. Prepare the surface
Remove all loose dirt and debris from the area to be coated. If required, clean and thoroughly dry the area. Remove any previous surface coatings with a wire brush and abrasive paper.
2. Shake the can vigorously before use
Apply from 15cm to 25cm in light coats. Do not flood. Apply lighter coats to avoid runs. Apply 2 or 3 light coats, allowing 15 minutes to dry in between coats. For the best results, ensure that the rusted surface is agitated with a wire brush or sandpaper before application.
3. Storage & Reuse
On completion of use, invert can and depress actuator for a few seconds to prevent nozzle blockage. This aerosol should be stored out of direct sunlight, in a cool well ventilated place.
Consult the safety data sheet before use.